How To Repair Bumper Scuff
Got a bumper scuff or scratch? While not as severe as a bumper crack or dent, a trip to an auto body repair shop tin can still cost an average of $560, and they volition probably need to keep your car for a few days. Why non ready it yourself? In this article we are going to prove yous how to repair a scratched urethane plastic or fiberglass bumper encompass on your own, in a fraction of the time, at a fraction of the toll.
What you need:
- Manufacturing plant-matched pigment in a spray can.
- Automotive spray primer.
- Automotive spray articulate coat.
- Some sheets of coarse and fine sandpaper.
- Scuff pad.
- Cleaning towel.
- Wax and grease remover.
- Scratch-filling putty.
Step 1. Utilize Masking Tape
Apply masking tape to adjacent panels and plastic trim that could be accidentally sprayed by bumper paint.
Pace 2. Sand Bumper
Wrap a canvass of fibroid sandpaper around your scuff pad, and sand the bumper with firm force per unit area until you have smoothed the scratches out.
Pace 3. Clean Panel
Once you are done sanding wipe down the panel with your cleaning towel, and then clean the entire panel with wax and grease-remover.
Step iv. Make full Scratches
Now if you find any scratches that will non sand out, make full them in with a sparse layer of scratch-filling putty.
Await five minutes for information technology to harden, and so re-sand over the putty using corse sandpaper with business firm pressure.
You lot might need to repeat this pace a second time in order to become everything smoothed out.
Step 5. Scuff Repair Area
Have your scuff pad and scuff at least ten inches all around the repair area.
This is very important considering information technology will help ensure that your paint volition permanently stick to your bumper and be more than durable over time.
Step 6. Prime number Bumper
Comprehend whatsoever areas that might be hit with unwanted overspray with newspaper or butcher paper.
Shake the primer can for almost sixty seconds, and apply a thin layer of primer.
Wait two minutes, so employ a heavier layer of primer until you have covered any bare black plastic areas exposed by sanding.
Stride vii. Paint Bumper
Using the fine-grit sandpaper, sand the primer with light pressure until information technology feels shine.
Shake the jar of pigment for about thirty seconds, then use multiple coats of paint, near 10-12 inches abroad.
If you run into any bumps, cloudiness, or "cat" scratches, just wait v minutes, sand again until smooth, and attempt once more.
If you have a silver or aureate auto and you notice any stripes, follow up with some vertical passes.
Step eight. Clearcoat Layer
Once y'all are done painting, wait at least five minutes before applying a light layer of clearcoat.
Wait two minutes before slowly apply a heavier layer, overlapping each pass past about l%.
Wait ten minutes, remove the record and paper, and you are done. Y'all can wash or wax; it is permanent.
We'll make it easier for you.
Fix bumper scrapes yourself, in just 45 minutes, with BumperWizard.
Source: https://scratchwizard.net/blog/how-to-repair-your-scratched-plastic-bumper/
0 Response to "How To Repair Bumper Scuff"
Post a Comment